Call 08046051047 83% Response Rate

Send Email

Fosroc Chemical

Prominent & Leading Distributor / Channel Partner from Ludhiana, we offer fosroc nitobond pc30.
Fosroc Nitobond PC30
  • Fosroc Nitobond PC30
  • Fosroc Nitobond PC30
  • Fosroc Nitobond PC30

Fosroc Nitobond PC30

Product Price: Rs 350 / KgGet Best Price

Product Brochure

Product Details:
Usage/ApplicationConcrete Surface
Packaging Size6kg
CategoryExpansion Joint Adhesive
Nitobond PCThixotropic epoxy adhesiveUsesBonding segmented concrete bridges to speed upconstruction and provide a structural and water resistant joint.Can be used for pointing Stone masonry joints to retainstructural integrity .Advantages Excellent squeezability High bond strength Fast cure Tolerant to damp surfaces Wide range temperature applicationsStandards complianceNitobond PC meets the FIP specifications in all respects.DescriptionNitobond PC thixotropic epoxy adesive is a 2 pack solventfree epoxy resin system consisting of a white base, blackhardener in preweighed quantities for easy onsite mixing.The product is available in three grades : Nitobond PC20 - Fast set for application between 50C t0200 C Nitobond PC 30 - Medium Fast set for application between150C to 300C Nitobond PC40 - Slow set for application between 250Cto 400CTechnical SupportThe company provides a technical advisory service supportedby a team of specialists in the field.PropertiesColourBase - WhiteHardener - BlackMixed - GreySpecific gravity at 300C1.60 - 1.65Cure characteristics Recommended Pot life ** Open Application (Mins.) Time Temperature (Mins.)Nitobond PC20 50C-200C 30 at 200C 60 at 200CNitobond PC30 150C-300C 30 at 300C 60 at 300CNitobond PC40 250C-400C 30 at 400C 60 at 400C** for 100 g of mixed materialMechanical propertiesSqueezabilityMeets the requirement(FIP 5.4)Compressive@ 24 hours > 40N/mm2Strength (FIP 5.6)@ 7days > 75N/mm2Tensile bending strength Concrete failure(FIP 5.14)Shear Strength 13N/mm2(FIP 5.15)Application instructionsSurface PreparationConcrete should be mechanically sound and free fromcontamination, such as free water, mould, oil or grease,laitence and dust. Grit blasting is recommended. Sectionsto be bonded should be checked for good alignment. A ''dryrun'' before the first application of the adhesive isrecommended to ensure correct timing.MixingThe base and hardener into a suitable container shall beemptied and mix with a paddle and slow speed heavy dutydrill, ensuring the sides are scraped down. A uniform greycolour should be obtained after mixing thoroughly.ApplicationThe mixed adhesive is applied to both surfaces to be bondedwith a serrated trowel or other suitable spreader.The joint should be closed immediately, if this is not achievedthe surface of the adhesive should be slightly scratchedimmediately prior to closing the joint to expose fresh adhesive.The joint must be closed within the open time of the adhesive.On site monitoring of the operation using lapped asbestoscement panels is recommended.
Get Best QuoteRequest A Callback


Contact Us
Thank youYour Enquiry has been sent successfully.
© R.S. Enterprises. All Rights Reserved (Terms of Use)Developed and managed by IndiaMART InterMESH Ltd.